Products > Carling Technologies
Switches NEW Expanded Range
Carling Technologies Switches are a popular range
of durable and reliable switch body as used as OE equipment throughout
the world by vehicle manufacturers such as Volvo, DAF, Renault, JCB and
Massey Ferguson .
MUD offers the Carling Contura II switches together with a range of
dedicated Carling switch mounts and accessories.
Carling Contura II switches are the exact
same type of switch as that used by ARB within its air-locker kits.
Square window illuminates green with sidelights matching the standard
Land Rover dashboard illumination.
Switch activation is indicated by orange LED bar. Wired with standard 6.3mm male spade terminals on rear of switches. Switches are supplied with wiring diagrams.
All Contura II switches are rated at 20amps All prices quoted below are inclusive of VAT.
On-Off
Standard on-off switch.
Green/Orange LED illumination. £6.00 (each)
On-Off
Exclusive to MUD-UK
Standard on-off switch except comes with
Red/Blue LED illumination.
Note: This switch is only available as an 'On-Off' £8.00 (each)
On-On-Off
Three position switch allowing you to wire two auxiliary circuits
through one switch. Typical application would be for controlling two
pairs of spotlamps or two electric fans via the one switch. Click switch once
to activate one circuit; click again to activate circuits one and
two. £7.00 (each)
On-Off-On
This alternative three position switch allows you to wire two auxiliary circuits
through the one switch.
This switch differs from that above in
that circuits one OR two are activated completely
independently of one another. £7.00 (each)
Off-Mom
Momentary spring loaded 1-way rocker switch.
Typical application would be a horn, screen wash control or as a one-way
internal winch control. Use two switches to control in &
out functions. £6.00 (each)
Mom-Off-MomSP (Single Pole)
Momentary spring loaded 2-way rocker switch.
Use the single pole switch when using the momentary switch as an internal hardwired
electric winch control. £7.00 (each)
Mom-Off-MomDP (Double Pole)
Momentary spring loaded 2-way rocker switch.
Use the double pole switch when using the momentary switch as an electric window
control. £7.50 (each)
Carling Switch
Mounts and Accessories. Our range of genuine CarlingSwitch accessories provide a
professional looking finish to any switch installation.
Use the gang mounts to install multiple switches within a single
mounting frame. Switches simply snap into place within the gang mount.
Single mounts provide a matching 'framed' finish to individual switch
installations.
The main advantage of using gang mounts is that you only have to cut one hole in a panel rather
than try horizontally align several individual holes when installing a row of
multiple switches.
Use the interlocking mounts to create multiple switch mounts
to suit your own requirements. Both the MUD Console and MudPod have
designed to accept the Carling switch mounts.
1-Switch Single Mount
Accepts one Carling switch. Switches click into mount. Dimensions (W x H): 34.03mm x 58.4mm
£1.00 (each) Switch not included
3-Switch Gang Mount Accepts three Carling switches. Switches click into mount. Dimensions (W x H): 86.3mm x 58.4mm
£2.75 (each) Switches not included
6-Switch Gang Mount Accepts six Carling switches. Switches click into mount. Dimensions (W x H): 164.8mm x 58.4mm
£5.00 (each)
Switches not included
Interlocking Mounts
These individual interlocking switch
frames allow you to create your own multiple gang mounts.
When ordering, use two frame ends for all installations. e.g. To
install five switches, order 3 x centres and 2 x ends. For
two switches side-by-side, use two interlocking ends.
Dimensions per end mount (W x H): 30.1mm x 58.4mm
Dimensions per centre mount (W x H): 26.2mm x 58.4mm £1.00 (each)
Switch Blanks
A neat and tidy way to fill unused holes in all switch mounts.
If you think you may be adding
more switches to your vehicle at a later date, 'future proof' your
installation by ordering a switch mount with more openings than you need
and just fill in the holes with blanks until you're ready to fill the
hole with a
switch.
£1.00 (each)
Rubber Switch Rockers Offering a more tactile soft touch feel than the standard plastic
rockers, these rubber rockers are a straight swap for the standard
switch rockers. £1.50 (each)
When ordering switches, add £1.50 to price of all switches for
rubber rocker upgrade.
Note: A Carling Switch Tool is required for swapping switch rockers.
Multi-Plug Connectors Tidy up a multiple switch installation with these dedicated Carling
multi-plug connector blocks. Connector plugs into back of Carling switch body.
Locking tab offers a secure connection. Requires 6.3mm female latching
spade terminals. (Not included. See Below)
Note that the total depth required for a switch and
connector is 50mm. Check available clearance. £1.00 (each)
Switch Terminals A bag of 50 non-insulated female crimp terminals for use with the
Carling multi-plug connectors. 6.3mm spade is latched for securing
into the connectors.
£1.50 (bag of 50)
Carling Switch Tool
Dedicated Carling switch tool for easy removal of switches from gang
mounts and/or removing switch fronts. Forked end removes rockers. Flat
end removes switches from gang mounts. £1.75 (each)
Switch Legends The Mud Legend sheet contains
84 individual legends for sticking onto the Carling switch windows. Each
legend is laminated for durability. Available in Black on Clear &
Clear on Black to permit legend illumination.
Click Here for more
details £7.00
How to Pay You can place your order by telephoning MUD UK, Monday to Friday between the hours of 9am & 5pm (GMT) on +44 (0) 1422 847704.
Personal callers by prior appointment only.
Payment details
We accept Mastercard, Switch, Maestro, Visa Electron, Solo, Visa and JCB.
Overseas customers can pay via PayPal.Contact us first for a shipping quote.
We also accept payment by cheque and postal order.